Antenna Connection - JVC LT-29DG43J Instructions Manual

Antenna connection

Note: Before you connect other appliances:
• To avoid potentially damaging your set, make sure all items are switched off and disconnected from the
mains power when you make the connections.
• Arrange the desired connection.
• When you have finished making the connections, reconnect the mains power to the unit and switch it
back on.
Connect your antenna as shown below (D). Connections to other equipment is explained further on
P.26-27. If you have problems with reception, consult a specialist of antenna.
(E)
(F)
(A)
(G)
(A) HDMI1/2/3 input: See P.26.
(B) AUDIO IN: Input for Audio input for component/AV (Sharing). See P.26-27.
(C) DIGITAL AUDIO COAXIAL output: digital audio output. See P.26.
(D) ANT. CABLE: Connect an antenna.
The built-in tuner receives all analogue cable programmes and DVB-T/-C channels.
(E) HEADPHONE jack: Plug headphones with a mini plug (3.5 mm) into this jack.
(F) USB input: See P.22-25.
(G) Y(VIDEO)/Pb/Pr input: Input for analogue Component-Signal. See P.26-27.
Note: AV-CVBS input is sharing with component input.
(H) C.I. slot: for CA- module (CAM) (if PayTV-provider supports this).
Note: To prevent malfunctions and damages, be sure to turn off the TV before inserting or removing
the CAM card.
(I) Bracket holes: Fix a wall mounting bracket (not supplied) here.
(J) To hang the television on a wall, remove these screws and then remove the stand.
Before performing work spread cushioning over an area to lay the TV on.
EN 10
Back Side
(H)
M4 x 10
100 mm
(I)
100 mm
(J)
(A)
(B)
(C)
(D)