Table of Contents
Advertisement
Operating the appliance
en
Control panel model 2
Control panel
Explanation
Fan on/off
#
Light on/off/dimming
A
-
Reduce the fan settings
+
Increase the fan settings/intensive setting 1, 2
Boost function (short-term maximum power)
&
Fan run-on time
x
Setting the fan
Switching on the appliance
Press the
button.
#
■
The fan starts at setting
Press the + or - button to change the fan strength.
■
Switching off
Press the
button.
#
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the + button when the fan is at setting
The intensive setting
2‚
button again activates the intensive setting
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before the preset time expires, press
the - button until the required fan setting is reached.
Boost function
The boost function is a short-term maximum power
setting which can be activated in any fan setting.
Press the
button. After approx. 20 seconds, the fan
&
switches back to the previously set fan setting.
Fan run-on time
Press the
button.
x
The fan continues to operate for a further 10 minutes,
and switches off automatically after this time. If the
lighting is switched on, it remains on.
Press the
button to end the fan run-on time early.
x
Lighting
The lighting can be switched on and off independently
of the fan.
Press the
button.
A
Setting the brightness
Press and hold the
button until the desired
A
brightness is reached.
6
.
ƒ
.
„
is activated. Pressing the +
2 ƒ
.
Saturation display
When the metal mesh grease filters or the activated
carbon filter are saturated, a signal sounds for approx.
4 seconds after the fan is switched off.
In addition, the corresponding symbol appears in the
display:
Metal mesh grease filter:
■
Activated carbon filter:
■
If you have not yet done so, the metal mesh grease
filters should be cleaned or the activated carbon filter
changed now.
For instructions on how to clean the metal mesh grease
filters, please refer to the section
.
maintenance
While the saturation displays are flashing, they can be
reset. To do this, press the – button.
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display
must be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Press the
#
and
x
■
the
display for starter sets for circulating-air mode
™"
or
the
display for CleanAir circulating air modules
'"
lights up.
Repeatedly press the button combination to switch
■
the electronic control display back to exhaust air
mode (
display).
!
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the
same time for approx. three seconds. An
acknowledgement signal sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
Control panel model 3
Control panel
Explanation
Fan on/off
#
Light on/off/dimming
A
-
Reduce the fan settings
+
Increase the fan settings/intensive setting 1, 2
Boost function (short-term maximum power)
&
Automatic mode with fan run-on time
!
!
"
Cleaning and
buttons at the same time until
and + at the
#
Advertisement
Table of Contents
