Table of Contents
Advertisement
Attaching and aligning the appliance
First, remove the protective foil from the back of the
1.
appliance and, following installation, remove the foil
completely.
When attaching the appliance, ensure that it
2.
engages firmly with the brackets.
Align the appliance horizontally by turning the
3.
brackets. If required, the appliance can be moved to
the right or left.
¬
Firmly tighten the screws for the brackets. When
4.
doing so, hold the brackets securely in place.
Firmly tighten the knurled nuts.
5.
«
®
¯
Connecting the pipes
If using an aluminium pipe, smooth the
Note:
connection area beforehand.
Exhaust-air pipe Ø 150 mm (recommended size)
Attach the exhaust-air pipe directly to the air-pipe
connector and seal.
Exhaust-air pipe Ø 120 mm
Attach the reducing connector directly to the air-pipe
1.
connector.
Attach the exhaust air pipe to the reducing
2.
connector.
Seal both joints appropriately.
3.
Attaching the flue duct
:
Warning
Risk of injury!
From sharp edges during installation. Always wear
protective gloves while installing the appliance.
Separate the flue ducts.
1.
To do this, remove the adhesive tape.
Remove the protective foil from both flue ducts.
2.
Push one flue duct into the other.
3.
Notes
– To prevent scratches, lay paper over the edges of
the lower flue duct to protect the surface.
– Slots of the inner flue duct point downwards.
Place flue ducts on the appliance.
4.
Push the inner flue duct upwards and attach it to the
5.
fixing brackets on the left and right.
Press the flue duct downwards until it engages.
6.
Screw the flue duct to the sides of the fixing bracket
7.
using two screws.
ª
Installation en
¨
©
15
Advertisement
Table of Contents
