Yamaha F80BETL Service Manual page 195

6. Install the new O-rings 9 and 0, and
backup ring A onto the trim piston B.
7. Install the balls C, valves D, and springs
E into the trim piston, and then install the
washer F and trim piston to the tilt cylin-
der G.
8. Install the filter H and washer I to the
trim piston.
B
C
D
E
G
9. Install the backup ring J and new O-ring
K to the tilt piston L.
10. Install balls M and N, valves O, springs
P, pins Q, dowels R, and washer S
into the tilt piston.
11. Hold the tilt ram end in a vise using alu-
minum plates on both sides.
12. Install the tilt piston to the tilt ram by
installing the bolt T, then tightening it to
the specified torque.
6D93G11
I
H
9
A
A
0
0
9
F
S60C7875
Tilt cylinder and trim cylinder
Tilt piston bolt T:
85 N·m (8.5 kgf·m, 62.7 ft·lb)
13. Install the tilt ram into the tilt cylinder.
14. Hold the tilt cylinder G in a vise using
aluminum plates a on both sides.
NOTE:
Place the tilt cylinder in the vise horizontally.
1
2
3
4
5
6
7
8
9
7-40