THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
W or less unless otherwise
4
specified.
•
: internal component.
¢
• C : panel designation.
Note:
Note:
Les composants identifiés par
The components identi-
une marque 0 sont critiques
fied by mark 0 or dotted
line with mark 0 are criti-
pour la sécurité.
cal for safety.
Ne les remplacer que par une
piéce por tant le numéro
Replace only with part
spécifié.
number specified.
• A : B+ Line.
• B : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
f
: AM
E
: PB (DECK A)
d
: PB (DECK B)
G
: REC (DECK B)
J
: CD
c : digital out
• Abbreviation
AR
: Argentina model
AUS
: Australian model
E51
: Chilean and Peruvian model
KR
: Korea model
MX
: Mexican model
SP
: Singapore model
SECTION 6
DIAGRAMS
Note on Printed Wiring Boards:
• X : parts extracted from the component side.
•
: Pattern from the side which enables seeing.
• Indication of transistor.
These are omitted.
Q
B
C E
These are omitted.
HCD-DX50/RG80
C
Q
B
E
19