Weider WESY19720 User Manual page 11

19. Loosen the M10 Nylon Locknut (21) on the
lower 3 1/2" Pulley (15) on the Press
Frame (17).
Locate the Short Cable (58). Route the
Short Cable (58) under the 3 1/2" Pulley (15).
Be sure that the end of the Cable with the
ball is on the indicated side of the Press
Frame (17) and that the Cable is between
the Pulley and the crossbar on the Press
Frame. Tighten the M10 Nylon Locknut (21)
and the M10 x 90mm Bolt (77).
20. Route the Short Cable (58) around the 3 1/2"
Pulley (15) attached to the lower hole in the
Front Upright (42). See the inset drawing.
Be sure that the Cable Trap (66) is turned
to hold the Cable in place and that the
Cable is routed around the Pulley as
shown. Tighten the M10 Nylon Locknut (21)
and the M10 x 95mm Bolt (71).
19
58
20
21
11
21
77
15
Crossbar
17
42
71
58
This view is from
the opposite side
42
15
58
Ball
15
66