Fitting And Removal Of Base : Prolite B2274Hds - Iiyama ProLite E2274HDS-2 User Manual

FITTING AND REMOVAL OF BASE : ProLite B2274HDS

 Put the monitor on a stable surface. The monitor may cause injury or damage if it falls
CAUTION
or is dropped.
 Do not give a strong impact to the monitor. It may cause damage.
 Unplug the monitor before removal or installation to avoid electric shock or damage.
<Installation>
A Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched.
Lay the monitor fl at on a table with front face down.
B Install the Stand-Base to the Monitor.
C Fix the Monitor to the Stand by both screws fi rmly and then push-down knob.
<Removal>
A Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched.
Lay the monitor fl at on a table with front face down.
B Pull up the knob, then remove the screws and the Stand-Base.
<Stopper pin>
Please stand the monitor and then remove the stopper pin
on the back of the stand slowly while pushing top face of
the stand before you install the monitor. Careful attention is
required as the monitor is sprung loaded and may expand
quickly when removing it.
Screw for Stand-Base fi xing
Stand-Base
BEFORE YOU OPERATE THE MONITOR 5
Push-down knob
Stopper pin