Fitting And Removal Of Base : Prolite B1906S - Iiyama ProLite B1906S-1 User Manual

FITTING AND REMOVAL OF BASE : ProLite B1906S

The monitor is supplied complete with a stand-base. If you prefer to wall mount the monitor, please
follow the instructions below to remove the stand-base. Be sure to include the stand with the monitor if
it is necessary to return the unit.

CAUTION Put the monitor on a stable surface. The monitor may cause injury or damage if it
falls or is dropped.

Do not give a strong impact to the monitor. It may cause damage.

Unplug the monitor before removal or installation to avoid electric shock or damage.
<Installation>
A Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay
the monitor fl at on a table with front face down.
B Install the Stand-Base to the Monitor.
C Fix the Monitor with the Stand by the screw fi rmly, and the knob of the screw push down.
<Remove>
A Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay
the monitor fl at on a table with front face down.
B Pull up the knob of the screws, and remove the screw and the Stand-Base.
<Stopper pin>
Please stand the monitor and then remove the stopper
pin on the back of the stand slowly while pushing top
face of the stand before you install the monitor. Careful
attention is required as the monitor is sprung loaded
and may expand quickly when removing it.
5 BEFORE YOU OPERATE THE MONITOR
Stand-Base
Screw for
Stand-Base fixing
Push-down knob
Stopper pin