Take Out Cassette Tape - JVC GR-D30EK Service Manual

2.8 TAKE OUT CASSETTE TAPE

NOTE :
The following procedure describes a simplified method of
ejecting the cassette tape in case it is not possible to eject it,
due to an electrical failure.
Be careful not to damage any of the parts or the tape when per-
forming repairs or maintenance work.
(1) Remove the Power Unit (battery, DC code, etc.) from the
set.
(2) Open the CASSETTE COVER.
(3) Attach a piece of PVC TAPE at the front of the CASSETTE
HOUSING ASSEMBLY.
NOTE:
This helps prevent the tape from being damaged when
the CASSETTE HOUSING ASSEMBLY is moved up-
ward at the unloading end.
(DC3V)
LOADING MOTOR
ASSEMBLY
1-16 (No.86730)
PVC T APE
CASSETTE HOUSING
ASSEMBLY
(4) Apply DC 3V to the electrode on the top surface of the
LOADING MOTOR ASSEMBLY to set the MECHANISM
ASSEMBLY to the EJECT mode.
Unloading end is EJECT mode.
(5) If there is any slack tape in the tape transport system, wind
it inside the DVC CASSETTE TAPE by turning the REEL
DISK ASSEMBLY (SUP) from the backside of the SLIDE
DECK ASSEMBLY.
(6) Peel off the PVC TAPE and take out the DVC CASSETTE
TAPE from the CASSETTE HOUSING ASSEMBLY.
NOTE:
Make sure that grease or a similar substance is not at-
tached to the surface of the tape.
Similarly, also make sure that grease or a similar sub-
stance is not attached on the MECHANISM ASSEMBLY.
CASSETTE COVER
Fig.2-8-1
REEL DISK ASSEMBLY (SUP)