Table of Contents
Advertisement
2.1.7 MECHANISM ADJUSTMENTS
2.1.7.1
Adjustment of the slide guide plate
Use Fig. 2-1-26 as the reference unless otherwise specified.
(1) Set the PLAY mode. See Fig. 2-1-8.
(2) Loosen the screws (A, B).
(3) With the Main Deck and Slide Deck Assemblies pushed into the unit, tighten the screws (A, B) while applying pressure to the
stud (shaft) on the Slide Guide plate.
The pressure applied should be enough to enable utilization of the rebounding force of the springs.
The tightening torque should be 0.069 N•m (0.7 kgf•cm).
(4) Check the operation.
Repeat unloading and loading several times and make sure that these operations can be performed smoothly without producing
rattles.
(3)
(
)
2)(3
SCREW A
(3)
STUD
(SHAFT)
(3)
(
2)(3
)
SCREW B
(3)
Fig.2-1-26
(3)
(No.86700)2-15
Advertisement
Table of Contents
