Table of Contents
Advertisement
Important Notes
Please take some time to read the section entitled 'Illustration
and Description' to identify the various parts of your machine
so that you are familiar with the terminology we will use to
enable you to set up and operate your table lathe safely and
correctly.
The lathe and its accessories will arrive coated with corrosion
preventative grease. This will need to be cleaned from the
lathe, its components and accessories prior to it being set up.
Wearing overalls and rubber gloves is advisable, as is eye
protection. After cleaning, lightly coat the machine with a
thin layer of light wax.
UNPACK YOUR NEW LATHE AND RECYCLE
THE PACKAGING RESPONSIBLY. THE CARD-
BOARD PACKAGING IS BIODEGRADABLE.
WARNING: THE WOOD LATHE IS A HEAVY
MACHINE, IT IS ADVISABLE TO USE A LIFTING
DEVICE SUCH AS A HOIST, SCISSOR LIFT OR
SEEK HELP WHEN ASSEMBLING THE LATHE.
WARNNING! WE RECOMMEND YOU REMOVE
THE HEADSTOCK, TOOL REST AND TAILSTOCK
FROM THE LATHE BED BEFORE LIFTING THE
LATHE ASSEMBLY OFF THE PALLET
PLEASE NOTE: The Trade Lathe comes 90%
pre-assembled. In order to reduce the footprint of the
machine for packaging, several items are dismounted from
the machine and need to be re-affixed. Please check all the
boxes, packets etc. to make sure that all the parts have
been accounted for.
1. Remove the headstock and tailstock stop pins to the ends of
the lathe bed and place safely aside, see fig 01-02.
Fig 01-02
2. Carefully remove the headstock, tailstock and tool rest banjo
and place safely aside, see fig 06-07-08.
NOTE: Before you remove the headstock assembly, first
remove the Electronic inverter control box from the pallet
by removing the two securing screws and place safely aside,
see fig 05.
3. Using a lifting device or seek help, lift the lathe bed from the
pallet onto a work bench in rediness to mount the leg stands
(M).
Stop Pin
7
Control box unit
Tailstock
Banjo
Headstock
Assembly
Fig 05
Phillips screws
Fig 06-07-08
Continues Over....
Advertisement
Table of Contents
