Camera Module - HP Pavilion DV2500 Maintenance And Service Manual

Camera module

If it has been determined that the camera module is the component that must be replaced to complete the
computer repair, the display assembly does not have to be removed. Follow the procedures in this section
to replace the camera module. For information on replacing the display assembly and other display
assembly internal components, see
Description
Camera module (includes camera module bracket and 2-sided tape)
Before removing the camera module, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Remove the camera module:
1.
Turn the computer display-side up, with the front toward you.
2.
Open the computer as far as it will open.
3.
Remove the four rubber screw covers (1) on the display bezel top edge. The display rubber screw
covers are included in the Rubber Feet Kit, spare part number 417095-001.
4.
Remove the four Phillips PM2.5×5.0 screws (2) that secure the display bezel top edge to the display
assembly.
5.
Flex the inside edges of the left and right sides (1) and the top edge (2) of the display bezel until
the bezel disengages from the display enclosure.
Display assembly on page
Battery on page 40).
59.
Spare part number
453673-001
Component replacement procedures 41