Camera/Microphone Module For Standard Display Assembly - HP DV4-2153 Maintenance And Service Manual

Camera/microphone module for standard display assembly

Description
Camera/microphone module (includes camera/microphone module bracket and 2-sided
tape)
If it has been determined that the camera/microphone module is the component that must be replaced
to complete the computer repair, the display assembly does not have to be removed. Follow the
procedures in this section to replace the camera/microphone module. For information on replacing the
display assembly and display assembly internal components replacement part numbers, see
assembly on page
Before removing the camera/microphone module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Remove the camera/microphone module:
1. Turn the computer display-side up, with the front toward you, and open the display as far as it will
open.
2. Flex the top edge (1), and the inside edges of the left and right sides (2) of the display bezel until
the bezel disengages from the display enclosure.
3. Release the display bezel top edge (3).
70 Chapter 4 Removal and replacement procedures
80.
Battery on page 55).
Spare part number
486876-001
Display