HP Pavilion DM4-1050 Maintenance And Service Manual page 97

4. Remove the fan/heat sink assembly (2).
The thermal material must be thoroughly cleaned from the surfaces of the fan/heat sink assembly
(1), (3) and the processor (2) and graphics processor (3) on the system board each time the fan/
heat sink assembly is removed. Thermal pads and thermal paste must be installed on all surfaces
before the fan/heat sink assembly is reinstalled.
The following illustration shows the locations for thermal material on systems with discrete graphics
subsystems.
NOTE: Steps 5 through 7 apply to computers with UMA subsystem memory on the system
board. Steps 1 through 4 apply to computers with discrete subsystem memory.
Component replacement procedures
87