d.
Top cover (see
e.
USB board (see
Remove the power connector cable:
1.
Turn the computer upright with the right side toward you.
2.
Disconnect the power connector cable (1) from the system board.
3.
Remove the two Phillips PM2.5×5.0 screws (2) that secure the power connector cable to the base
enclosure.
4.
Lift the bracket from the connector (3).
5.
Remove the power connector (4) from the base enclosure.
Reverse this procedure to install the power connector cable.
78
Chapter 4 Removal and replacement procedures
Top cover on page
64)
USB board on page
76)