Table of Contents
Advertisement
• If a preset memory has already been set in the same preset number, it
will be cleared and the new station will be memorized.
Presetting Stations Automatically
The tuner can automatically seek and store 6 strong stations in the
selected band in order of signal strength.
After selecting the desired band, touch [A.Memo] of
Bottom banner.
The tuner automatically seeks and stores 6 strong stations into
the preset buttons in order of signal strength.
When automatic storing has completed, the station stored in the
preset 1 is selected.
If [A.Memo] is not displayed, touch [<<] or [>>] in the bottom
banner to display [A.Memo].
• If no stations are stored, the tuner will return to the original station
you were listening to before the automatic storing procedure began.
• You can cancel this process by touching [A.Memo] while the tuner is
automatically seeking stations. Cancelling will return the tuner
preset to the previous setting.
Tuning to Preset Stations
You can tune in the preset stations in memory on either band using its
preset number.
1
Touch [Band] of Bottom banner repeatedly until the
desired band is displayed.
2
Touch any one of the preset buttons that has a
station stored to it.
The preset station is received.
Forced Analog Mode
Touch the [Digital/Analog] button to receive analog broadcasts only.
Touch [Digital/Analog].
• If digital broadcast is received, this operation switches reception to
analog mode.
• During Forced Analog mode, only analog broadcasts will be received
even when digital broadcasts become available.
32
-EN
Receiving a Multicast (HD Radio mode
only)
Multicasting is the ability to broadcast multiple program streams over a
single FM frequency. This increases the amount and diversity of content
choices. A maximum of 8 multicast station channels can be selected on
this unit.
• Multicast indicator appears when signal reception is possible.
• The station number of the current broadcast station appears behind
the frequency (ex. 90.3 MHz-HDs means there are 5 stations on
90.3 MHz).
Touch [
] or [
].
The sub channel of the received radio station is changed.
• If reception is lost during SPS broadcasting due to weak or no signal,
the screen will display "HDx Signal loss."
If SPS broadcast reception is lost for over 100 seconds, reception will
switch over to MPS broadcast (the reception mode will automatically
return to SPS when SPS broadcasts become available again).
PTY (Program Type) Tuning (Analog
Broadcasts only)
FM Radio mode
1
Touch [PTY Search] of Bottom banner.
The Select PTY list screen is displayed.
If [PTY Search] is not displayed, touch [<<] in the bottom
banner to display [PTY Search].
2
Touch the selected program type to start searching
for a station in the type.
If no PTY station is found, "No PTY." will be displayed.
3
Touch [Tune] to choose the PTY tuning mode.
The PTY mode is activated.
4
To select the station in the PTY, touch [<] or [>].
Advertisement
Chapters
Table of Contents
