Table of Contents
Advertisement
Radio
Display example for Radio main screen
Band display
Frequency display
Preset button
Seek mode
Listening to the Radio
1
Touch [Radio] of Top banner.
The radio mode is activated and the display changes to the
Radio mode screen.
2
Touch [Band] of Bottom banner to select the
desired radio band.
Each touch changes the bands as follows:
FM1
FM2
FM3
3
Touch [Tune] to select the tuning mode.
DX Seek
Local Seek
* For details, refer "PTY (Programme Type) Tuning" (page 20).
• There are two modes you can select for auto tuning, DX and
Local:
- DX (Distance) mode;
Both strong and weak stations will be tuned in.
- Local mode;
Only strong stations will be tuned in.
The initial setting is DX.
4
Touch [ ], [ ], [ ] or [ ] to change the radio
frequency up or down respectively.
In manual mode, touch and hold to change the frequency
continuously.
18
-EN
MW
LW
FM1
Manual
PTY Seek*
Presetting Stations Manually
1
Tune in a desired radio station you wish to store in
the preset memory by manual or automatic seek
tuning.
2
Touch and hold any one of the preset buttons for at
least 2 seconds.
The selected station is stored.
3
Repeat the procedure to store up to 5 other stations
onto the same band.
To use this procedure for other bands, simply select the
desired band and repeat the procedure.
A total of 30 stations can be stored in the preset memory
(6 stations for each band; FM1, FM2, FM3, MW or LW).
• If a preset memory has already been set in the same preset number, it
will be cleared and the new station will be memorised.
Presetting Stations Automatically
The tuner can automatically seek and store 6 strong stations in the
selected band in ascending order of frequency.
After selecting the desired band, touch [A.Memo] of
Bottom banner.
The tuner automatically seeks and stores 6 strong stations into
the preset buttons in ascending order of frequency.
When automatic storing has completed, the station stored in the
preset 1 is selected.
• If no stations are stored, the tuner will return to the original station
you were listening to before the automatic storing procedure began.
• You can cancel this process by touching [A.Memo] while the tuner is
automatically seeking stations. Cancelling will return the tuner
preset to the previous setting.
Tuning to Preset Stations
You can tune in the preset stations in memory on either band using its
preset number.
1
Touch [Band] of Bottom banner repeatedly until the
desired band is displayed.
2
Touch any one of the preset buttons that has a
station stored to it.
The preset station is received.
• Each time you press the
the frequency registered into the preset buttons (1 through 6).
,
buttons, you can also change
Advertisement
Table of Contents
