Table of Contents
Advertisement
DisplayPort Ver.
Select your DisplayPort version.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the monitor (when set to HDMI,
DisplayPort1
message
Check the cable connection and the settings of the source device.
press the JOG button to display the function-button screen and then select the
Screen Display (OSD). You can select 1.1,
1.2
or 1.4.
― If setting the
DisplayPort Ver.
to 1.1, for the bandwidth limitation of the DisplayPort 1.1 protocol, the actual
maximum output refreshing rate of the display cards cannot achieve the level of 120 Hz.
― If you select 1.4, the monitor can support up to 5120 x 1440 @ 120 Hz.
― If you use 5120 x 1440 in DisplayPort source, you can't select 1.2.
or DisplayPort2) is in power saving mode or is displaying the
or power saving mode activates,
button to display the On
HDMI Mode
Select the HDMI mode to use.
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― Some high resolutions may not be supported due to the bandwidth limit in HDMI
Mode
is set to
1.4
or 2.0.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the
device.
― Set
HDMI Mode
to
1.4
or
2.0
if sound from the connected DVD player is missing.
― This menu is not available when
PBP
is enabled.
Source Detection
Select either
Auto
or
Manual
as the method to recognize input signal.
Key Repeat Time
Control the response rate of a button when the button is pressed.
Acceleration,
1
sec, or
2 sec
can be selected. If
when a button is pressed.
1.4
protocol while
No Repeat
is selected, a command responds only once
HDMI
44
Advertisement
Table of Contents
