Table of Contents
Advertisement
Note
1
The supported USB disk formats are FAT, FAT32, and NTFS.
2
For the CRG9 model, make sure that each upgrade file is a BIN format file, follows the CRG9 model
naming rule (m-RG949CCAA-****.*[4 digits].bin, where ****.* is a version number, and 4 digits are
a checksum. For example, "m-RG949CCAA-1000.0[6E80].bin" complies with the naming rule for the
CRG9 model.), and must be copied to the root directory.
3
Make sure that the USB disk only contains one upgrade file for each model, and then follow the
instructions in this guide.
4
If the
No valid update files found. Please check your USB device and try again.
this is probably due to the following reasons.
Update now
No valid update files found.
Please check your USB device and try again.
OK
‒ No USB disk is inserted into the
‒ The USB disk format is not supported.
‒ The USB disk contains no valid upgrade files. (No upgrade files exist, or the file names are
incorrect.)
5
Do not turn off the monitor. And prevent the upgrading from any interruption as far as possible. If an
interruption happens, the monitor will return to the production version.
― Note that the production version may not be the same as the version before this upgrading if some other
upgrading has been done earlier.
message is displayed,
Cancel
port.
15
Advertisement
Table of Contents
