Tidying Up The Connected Cables - Samsung LC49RG90 User Manual

Tidying Up the Connected Cables

: Headphones hanger
: Downward
: Upward
1
Connect the corresponding cables.
Remove the COVER STAND BODY REAR
by pulling it in the direction as shown in
the figure.
2
Arrange the cables against the bend
tendency of the cables and pull the cables
out of the COVER-REAR SUB grooves.
Place the corresponding cables into
the stand-neck holder. Do not stretch
the cable. Three cables in one holder is
recommended.
11
Open the Headset Hanger by pushing it
down.
Hang the HOLDER-CABLE in the direction
as shown in the figure.
Attach the COVER STAND BODY REAR in
the direction as shown in the figure with
the buckles not being exposed.
12
Hang the headset.
Arrange the cables against their bend
tendency, and then pull them through the
HOLDER-CABLE hangers. When the set
height is changed, you need to arrange
the cables and pull them through the
HOLDER-CABLE hangers again.
Move down the COVER STAND BODY
REAR until it covers the stand neck
completely.
13
Rotate and then push up the Headset
Hanger in the directions as shown in the
figure.
Push the COVER STAND BODY REAR in
the direction as shown in the figure.
Adjust the set height, if required.
Caution
Open the COVER-REAR SUB in the
direction as shown in the figure.
26