Fingerprint Reader Board - HP EliteBook 6930p Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes cable)
Before removing the fingerprint reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following:
a. Hard drive (see
b. Keyboard (see
c. Switch cover (see
d. Display assembly (see
e. Top cover (see
f. Audio/ExpressCard assembly (see
Remove the fingerprint reader board:
1. Remove the fingerprint reader board cable (1) from the opening in the top cover.
2. Remove the fingerprint reader board (2) by lifting it straight up. The fingerprint reader board is
attached to the top cover using double-sided tape.
Reverse this procedure to install the fingerprint reader board.
86 Chapter 4 Removal and replacement procedures
Battery on page 43).
Hard drive on page 49)
Keyboard on page 57)
Switch cover on page
Display assembly on page
Top cover on page 82)
Audio/ExpressCard assembly on page
66)
77)
Spare part number
486309-001
89)