Touchpad - HP EliteBook 6930p Maintenance And Service Manual

8. Remove the top cover (2) by lifting it straight up.
Reverse this procedure to install the top cover.

TouchPad

Description
TouchPad (includes cable and TouchPad button board and cable)
Before removing the TouchPad, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following:
a. Hard drive (see
b. Keyboard (see
c. Switch cover (see
d. Display assembly (see
e. Top cover (see
Remove the TouchPad:
1. Turn the top cover upside down, with the front toward you.
2. Remove the four Phillips PM2.0×3.0 screws (1) that secure the TouchPad bracket to the top cover.
3. Release the TouchPad bracket (2) by sliding it toward the back of the top cover.
84 Chapter 4 Removal and replacement procedures
Battery on page 43).
Hard drive on page 49)
Keyboard on page 57)
Switch cover on page
Display assembly on page
Top cover on page 82)
66)
77)
Spare part number
486306-001