Advertisement
3. Place the Console Base (46) on the tubes on the Uprights
(11). Pull out the two Wires (21) just enough to connect
them to the two connectors in the Console Base. Make a
loop with the indicated plastic tie and insert the end
through the tie holder on the bottom of the Console Base.
Plug the Wire that has a red connector into the corre-
sponding connector in the Console Base. The connectors
should fit together without being forced; if they do not, ro-
tate the red connector on the Wire and try again. Do not
force the connectors together. Next, plug the other
Wire into the other connector on the Console Base.
Important: Make sure that both Wires are fully in-
serted. WARNING: Do not disconnect or connect the
Wires while the treadmill power cord is plugged in. Pull
the plastic tie tight and cut off the end.
Refer to drawing 3b. Thread six Console Screws (88) into
the Uprights (11) and the Console Base (46). After all six
Console Screws have been started, tighten the Screws
until they are snug. Do not overtighten the Screws.
4. Attach the Storage Latch (14) to the left Upright (11) with
two Small Screws (13). Be careful not to overtighten
the Screws.
5. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the
floor or carpet, place a mat under the treadmill.
All manuals and user guides at all-guides.com
6
3a
46
21
11
3b
11
88
88
4
14
21
Tie
46
11
88
13
11
Advertisement
