Table of Contents
Advertisement
Subtitle Language
To set the Subtitle Language to your preferred language,
follow these steps. If your preferred language is
available on a DVD, your Subtitle Language will
automatically be set to the language you choose.
1 Open "MENU"
Press the MENU button while the DVD is in Stop
mode.
2 Select "DVD"
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
3 Select "Language"
Move the selection bar to "Language" then press
ENTER to select.
4 Select "Subtitle"
Highlight "Subtitle", then press the ENTER button.
5 Set "Subtitle Language" Preference
Highlight your preferred language for subtitles, then
press the ENTER button.
Subtitle Language
Automatic
Subtitle
Digital Output
If your A/V receiver is equipped with a Dolby Digital
decoder, your DVD-VCR can output Dolby Digital 5.1
sound, but you MUST enable this feature in the menu
system to prevent damage to your speakers.
NOTE: Select "Bitstream" ONLY if you have connected
a Dolby Digital-equipped A/V receiver to the
Digital Output (coaxial) on the DVD-VCR rear
panel.
1 Open "MENU"
Press the MENU button while the DVD is in Stop
mode.
2 Select "DVD"
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
3 Select "Audio"
Highlight "Audio", then press the ENTER button.
4 Set "Digital Output"
Highlight "Digital Output" then press the RIGHT
button to select one of the following options:
• PCM –
To use your DVD/TV with an A/V
receiver without a Dolby Digital
decoder.
• Bitstream –To use your DVD/TV with an A/V
receiver with a Dolby Digital decoder.
PCM
Bitstream
PCM Down Sampling
: On
ENG-16
DTS
If your A/V receiver is equipped with a DTS decoder,
your DVD-VCR can output DTS digital sound, but you
MUST enable this feature in the menu system.
NOTE: Select "On" ONLY if you have connected a
DTS-equipped A/V receiver to the Digital audio
Out (coaxial) on the DVD-VCR rear panel.
1 Open "MENU"
Press the MENU button while the DVD is in Stop
mode.
2 Select "DVD"
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
3 Select "Audio"
Highlight "Audio", then press the ENTER button.
4 Set "DTS"
Highlight "DTS" then press the RIGHT button to
select one of the following options:
• Off – To use your DVD/TV with an A/V receiver
NOT equipped with a DTS decoder.
• On – To use your DVD/TV with an A/V receiver
equipped with a DTS decoder
Off
On
PCM Down Sampling
: On
Dynamic Compression
Dynamic Compression restrains the dynamic range of
sounds, i.e. the difference between the loud and quiet
passages of a DVD audio track.
1 Open "MENU"
Press the MENU button while the DVD is in Stop
mode.
2 Select "DVD"
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
3 Select "Audio"
Highlight "Audio", then press the ENTER button.
4 Set "Dynamic Compression"
Highlight "Dynamic Compression", then press the
RIGHT button to select one of the following options:
• On – This will compress the total dynamic range
of the DVD audio, making quiet passages
in the audio signal louder and loud
passages softer.
• Off – This will preserve the original dynamic
range.
On
On
On
Off
Off
PCM Down Sampling
: On
ENG-17
Advertisement
Table of Contents
