Optional Kit Installations; Optional Blower Kit Installation; 1150 Blower Installation (Ep65) - Napoleon EPA 1400 Installation And Operating Instructions Manual

6.0 OPTIONAL KIT INSTALLATIONS

6.1

OPTIONAL BLOWER KIT INSTALLATION

TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
ENSURE THAT THE FAN'S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
Provisions have been made on the stove to install an optional blower kit (EP62-1) that comes complete with
a variable speed switch to turn the blower on and off, as well as adjusting the blower speed. An optional
thermostatic sensor control kit, EP36, to thermally activate the blower is also available.
Drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must be taken to
prevent drywall dust from coming into contact with the blower or its compartment. Any damage resulting from
this condition is not covered by the warranty policy.
Use of the blower increases the output of heat.
Attach the mounting bracket to the blower assembly. Then attach the mounting bracket to the back of your
appliance, push on the variable speed knob and plug into any grounded electrical outlet.
Do not remove the knock out on the back of the appliance.

6.1.1 1150 BLOWER INSTALLATION (EP65)

A. Remove the knock-out from the back of the appliance.
B. Install the blower and housing as shown using the 4
screws supplied.
C. Loosen the thermal switch bracket (2 screws) and
slide the bracket forward until the thermodisc is
touching the rear fi rebox and secure.
See "BLOWER INSTALLATION" leafl et for detailed
instructions.
WARNING
!
RISK OF FIRE AND ELECTRICAL SHOCK.
VOID THE WARRANTY AND CERTIFICATION.
CORD BENEATH THE APPLIANCE.
CONTACT WITH MOVING OR HOT OBJECTS.
B L
O W
2
K N
O C
SCREWS
E R
THERMAL SWITCH
BRACKET
3
51.5
K - O
U T
1
W415-0763 / B / 10.28.11
23