Bios Setup - Siemens SIMATIC IL43 Operating Instructions Manual

Detailed descriptions

15.3 BIOS Setup

15.3 BIOS Setup
15.3
You can configure the system functions and hardware configuration in the BIOS.
The factory BIOS settings of the Rack PC deviate from the default BIOS settings as follows:
Tab
Main
Advanced
Power
The Bios5-06.pdf manual on the supplied "Documentation & Drivers" CD shows you how to
access and change the BIOS setup. The manual also contains detailed descriptions of the
menus and setting options offered by the BIOS setup.
Notice
Updating the BIOS or calling the "Default settings" function changes the BIOS settings. If this
occurs, configure the BIOS again according to the specifications in the table.
Pay special attention to the correct settings in the Power tab.
All menu items are disabled by default.
The operating system functions "Save to RAM" (standby) and "Save to Disk" (hibernate) are
not approved for the Rack PC.
15-2
Option
Boot Options -> Post Errors
Boot Options -> Quiet Boot
Peripheral Configuration -> USB
BIOS Supported Devices
Peripheral Configuration -> ATA
controller config > S-ATA mode
Peripheral Configuration -> LAN
Remote Boot
Hyper-Threading
System Mode Config.
APM Interface
APM Power saving
ACPI Save to RAM
Power Failure Recovery
Setting
No Halt On Any Errors
Disabled
All
RAID (optional for RAID systems)
Disabled
Disabled (on Windows 2000 systems)
Performance
Disabled
Disabled
Disabled
Always on
Operating Instructions, Edition 09/2005, A5E00432875-01
SIMATIC Rack PC IL 43