Connect To The Internet; Enable Communication Hardware - HP Compaq NC6110 Getting Started Manual

Next Steps
If the notebook does not respond, try the following shutdown
procedures:
■
Press
■
If the notebook does not respond to the ctrl+alt+delete
procedure, press and hold the power/standby button for at
least 5 seconds.
Ä

Connect to the Internet

To connect the notebook to the Internet, you must enable your
communication hardware and have an account with an Internet
service provider (ISP). All Internet connection software
procedures are performed in Windows.

Enable Communication Hardware

Your modem is enabled when the modem cable is
connected to the notebook and to an analog telephone line.
■
If you connected the modem cable during hardware setup,
your modem is enabled. Proceed to
next in this chapter.
■
If you did not connect the modem cable during hardware
setup:
a. Turn off your notebook.
b. Follow the instructions in the
c. Start your notebook in Windows.
d. Then proceed to
3–8
ctrl+alt+delete
You should use the power/standby button to shut down the
notebook only when the system does not respond to any of
the shutdown procedures listed above. Using the
power/standby button to shut down the system can result in
file corruption and data loss.
section of Chapter 1, "Hardware Setup."
chapter.
. Then, select Shut Down > Turn Off.
"Step 3: Connect the Modem"
"Set Up Internet Service"
"Set Up Internet Service"
next in this
Getting Started