Back Panel; 4-Port Network Interface - Shure MXW6W Manual

Hardware Interface Description

Back Panel

②
Input: 100-240V ~ TBD A max. 50/60 Hz
①
① AC Power
IEC connector 100 - 240 V AC.
② Power Switch
Powers the unit on or off.
③ Output Block Connectors (1-8)
Three-pin, low-voltage connector provides a direct output for each
channel.
④ Chassis Ground
Use to directly ground the cable shield to the chassis.
⑤ Input Block Connectors (A,B)
Three-pin, low-voltage connector adds line- or aux-level analog signals
to the digital network.

4-Port Network Interface

Port Description
Provides Power over Ethernet (PoE) for the
Port 1 (PoE)
Shure MXWAPT Access Point.
Connects to an additional ANI for clock syn-
Ports 2 and 3 chronization, to an MXW charger, or to a con-
trol system.
By default, this port functions the same as
ports 2 and 3. However, it can be configured to
provide password protected uplink to corporate
LAN without network audio traffic. When Port 4
Port 4 (Uplink)
Uplink is enabled from the GUI, it only provides
access to the GUI, blocking data to the Shure
Discovery Application, Dante Controller and
Dante Virtual Soundcard.
19
④
MXWANI8
③
⑤
⑥ Reset Button
Press and hold the button for five seconds to reboot the device with
factory default settings.
⑦ Network Status LED (Green)
Off = no network link
On = network link established
Flashing = network link active
⑧ Network Speed LED (Amber)
Off = 10/100 Mbps
On = 1 Gbps
⑨ Network Interface
Digital Audio connection and networking capabilities with shielded Cat-
5e (or higher) cable.
4 3
uplink
⑨
4 3 2 1
uplink Class 0 PoE
⑥ ⑦ ⑧
2 1
Class 0 PoE