Access Point Transceiver (Apt) - Shure MXW6W Manual

Hardware Interface Description
① Power LED
Illuminates green when Power over Ethernet (PoE) is provided.
② Network Audio LED
• Solid Green: Sending or receiving a digital audio signal.
• Flashing Green: Cannot establish a connection.
③ RF Link LED
Color Status
≥1 linked microphone is powered on in the
Green
Active or Mute state.
≥1 linked microphone is in the Standby or Off
Solid Yellow
state.
Flashing Yellow The ID button in the GUI has been pressed.
Solid Red Problem with RF connection ???
Flashing Red No microphones are linked to the unit.
④ Reset Button
Press and hold the reset button for 10 seconds to hard reset the MXW
system to factory default settings.
Note: Performing a reset will delete system configurations made in the
GUI, including device association and microphone link.
⑤ Ethernet Jack
Connects a Cat5e (or higher) cable to a PoE source and the network.
⑥ Network Status LED (Green)
Off = no network link
On = network link established
Flashing = network link active
⑦ Network Speed LED (Amber)
Off = 10/100 Mbps
On = 1 Gbps
⑧ Cable Routing Path
Routes the Ethernet cable to enable a flush-mount to the surface.
17

Access Point Transceiver (APT)

⑥
⑦
⑤
① ② ③
④
⑧