Table of Contents
Advertisement
Message/Symptom
Computer will not perform a Wake On LAN
Dead computer. See "Hard disk drive boot error" on page
74.
Diskette drive in-use light remains on or does not light
when drive is active.
Blank screen except for flashing cursor.
Incorrect memory size during POST
"Insert a Diskette" icon appears with a known-good
diagnostics diskette in the first 3.5-inch diskette drive.
Intensity or color varies from left to right of characters and
color bars
No power or fan not running
Non-system disk or disk error-type message with a
known-good diagnostic diskette.
Other display symptoms not listed above (including blank
or illegible display)
Power-on indicator or hard disk drive in-use light not on,
but computer works correctly
Printer problems
78
P330 Tiny Hardware Maintenance Manual
FRU/Action
®
(if applicable)
1. Check the power supply and signal cable
connections to the network adapter.
2. Ensure that the operating system settings are set to
enable Wake on LAN.
3. Ensure that the Wake On LAN feature is enabled in
Setup/Configuration.
4. Ensure that the network administrator is using the
correct MAC address.
5. Ensure no interrupt or I/O address conflicts.
6. Network adapter (advise network administrator of
new MAC address)
1. Power Supply
2. System Board
1. Diskette Drive
2. System Board
3. Diskette Drive Cable
1. System Board
2. Primary Hard Disk Drive
3. Hard Disk Drive Cable
1. Run the Memory tests.
2. Memory Module
3. System Board
1. System Board
2. Diskette Drive Cable
3. Network Adapter
1. Display
2. Video adapter (if present)
3. System Board
1. See "Hard disk drive boot error" on page 74.
1. Diskette Drive
2. System Board
3. Diskette Drive Cable
1. Display
2. System Board
1. Power switch/LED assembly
2. System Board
1. Printer
2. System Board
Advertisement
Table of Contents
