b. Install the system fan.
Figure 48. Installing the system fan
7. Connect the system fan cable to the system fan connector on the system board. See "Parts on the
system board" on page 32.
8. Reinstall the computer cover and reconnect the cables. For details, see "Completing the parts
replacement" on page 131.
Heat sink
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
1. Remove any media from the drives and turn off all connected devices and the computer.
2. Disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
3. Remove the computer cover. For details, see "Computer cover" on page 95.
4. Remove the internal speaker if necessary. For details, see "Internal speaker" on page 100.
5. Remove the system fan. For details, see "System fan" on page 105.
6. Replace the heat sink.
a. Remove the heat sink.
Figure 49. Removing the heat sink
106
P330 Tiny Hardware Maintenance Manual