Power Supply - Compaq Armada e500s Maintenance And Service Manual

5.14 Power Supply

CAUTION: Do not handle or carry the power supply by the wiring harness. This can cause
damage to the power supply and wiring harness.
1. Prepare the expansion base for disassembly (Section 5.3).
2. Remove the tray (Section 5.4).
3. Remove the rear bezel (Section 5.6).
4. Remove the top cover (Section 5.8).
5. Disconnect the power supply cable connected to the backplane .
6. Remove the four screws
(Figure 5-29).
Figure 5-29. Disconnecting the Power Supply Cable and Removing the Power Supply Screws
CAUTION: Make sure the power supply cables are properly unclipped from the backplane
before disconnecting the power supply cables.
that secure the power supply to the base cover
Removal and Replacement Procedures 5-29