5.9 Half-Height Bay
The expansion base features one standard half-height bay, located on the left side of the
expansion base. This bay supports any standard half-height drive, such as a diskette or
hard drive.
Installing a Half-Height Drive
1. Prepare the expansion base for disassembly (Section 5.3).
2. Remove the tray (Section 5.4).
3. Remove the connector cover (Section 5.5).
4. Remove the rear bezel (Section 5.6).
5. Remove the top cover (Section 5.8).
6. Remove the three screws
(Figure 5-14).
7. Lift the bezel cage out of the base cover
Figure 5-14. Removing the Bezel Cage
5-14
Removal and Replacement Procedures
that secure the bezel cage to the base cover
.