Chevrolet UPLANDER 2007 Owner's Manual page 320

To use the RSE OSD menu when using a CD or
an MP3, do the following:
Make sure that a CD or an MP3 is loaded in the
RSE system and that the system is not in auxiliary,
then press the display button on the remote control.
Once the menu is on the screen, use the directional
arrows and the enter button to navigate the screen.
This menu will let you select default preferences for
language and playback settings. To exit this menu,
press the display or the return button on the remote
control or wait for the menu to time out.
Battery Replacement
To change the remote control batteries, do the
following:
1. Slide the battery door, located on the back of
the remote control, down.
2. Replace the two AA batteries in the
compartment. Make sure that they are
installed correctly, using the diagram on the
inside of the battery compartment.
3. Close the battery door.
If the remote control is to be stored for a long
period of time, remove the batteries and keep them
in a cool, dry place.
320
Tips and Troubleshooting Chart
Problem
No power.
Disc will not play.
No sound — Wireless
Headphones
No sound — Wired
Headphones
Recommended Action
The ignition may not be
in ACCESSORY, RUN,
or RAP.
The system might be off.
The parental control
button might have been
pressed. The power
indicator lights will flash.
The system might be in
auxiliary source mode.
Press the AUX button to
switch between the DVD
player and the auxiliary
source. The disc is upside
down or is not compatible.
Turn the headphones on.
Make sure the correct
channel is selected on the
wireless headphones.
Check the batteries. The
volume on the
headphones could be too
low, adjust the volume.
Make sure the wired
headphones are plugged
in. Adjust the volume. If
RSA is on, DVD audio will
not be heard.