Chevrolet UPLANDER 2007 Owner's Manual page 127

To manually shut off the engine after a remote
start, do any of the following:
•
Aim the remote keyless entry transmitter at
the vehicle and press the remote start
button until the parking lamps turn off.
•
Turn on the hazard warning flashers.
•
Insert the vehicle's key into the ignition switch
and turn the switch to RUN and then back
to LOCK.
The remote vehicle start feature will not operate if:
•
The remote start system is disabled. See
"REMOTE START" under DIC Vehicle
Personalization (Uplevel Only) on page 275.
•
The vehicle's key is in the ignition.
•
The vehicle's hood, liftgate or doors are not
closed.
•
The hazard warning flashers are on.
•
There is an emission control system
malfunction.
•
The engine coolant temperature is too high.
•
The oil pressure is low.
•
Two remote vehicle starts have already been
provided. The maximum number of remote
starts or remote start attempts between ignition
cycles with the key is two.
Remote Start Ready
If your vehicle does not have the remote vehicle
start feature, it may have the remote start
ready feature. This feature allows your dealer to
add the manufacturer's remote vehicle start
feature.
If the keyless entry transmitter has a plus (+)
symbol on the back cover, your vehicle has the
remote start ready feature. You can lock or
unlock your vehicle from approximately 197 feet
(60 m) away.
See your dealer if you would like to add the
manufacturer's remote vehicle start feature to your
vehicle.
127