Table of Contents
Advertisement
The procedure to set up the user password is the same as "Set Admin Password".
NOTE:
1. You can not set up the user password unless the administrator
password has been set up.
2. If both the administrator and user passwords are set up, only one
password is required to boot the system.
3. To modify the SCU settings, you have to enter the administrator
password. The user password only allows you to browse the
settings.
4. If the "Resume System" item is checked, the password is required
only when the system is restored from "Suspend-to-disk" status.
5. When setting the user password, if you do not specify any "Verify
password when..." condition (i.e. no item is checked), the password
will not be set up.
Memory Menu
The Memory pull-down menu, as shown below, allows you to change the settings
for memory usage.
Memory
Cache Systems
Cache Systems
This menu item lets you to enable or disable the usage of the L2 cache memory.
When this item is selected, the submenu will display as shown below.
( ) Disabled
( ) Enabled
The default setting is Enabled.
Setup Configuration Utility
5-7
Advertisement
Table of Contents
