Onkyo TX-NR6100 Instruction Manual page 134

Initial Setup with Auto Start-up Wizard
Operations
TV's REMOTE
Inputs
INPUT
TV
HDMI 1
HDMI 2
HDMI 3
When you turn the unit on for the first time after purchase, the Initial Setup
screen is automatically displayed on the TV to allow you to make settings
required for startup using simple operations following on-screen guidance.
1. Switch the input of the TV to the input connected to the unit.
2. Put batteries into the remote controller of this unit.
3. Press on the remote controller to turn the unit on.
4. When the language selection screen is displayed on TV, select the language
with the cursors / and press ENTER.
5. To make the network connection settings, select "Yes" and press ENTER.
• Select the item with the cursors of the remote controller, and press ENTER to
confirm your selection. To return to the previous screen, press
• If you have terminated the Initial Setup halfway, turn this unit to standby mode
and turn the power on again. Then you can display the Initial Setup again.
Unless you do the Initial Setup to the end or select "Never Show Again" in
the screen shown after setting the Network Connection, the wizard screen is
shown every time the power is turned on.
• To perform the Initial Setup again after the setting is completed, press
select "7. Miscellaneous" - "Initial Setup", and press ENTER.
/ / /
ENTER
Setup
.
MEMORY
CLEAR
,
134