Administration Tab; Firewall; Ssl Certificates; Services - Teledyne FLIR A50 Series User Manual

10
Camera web interface
10.4.17.1 Saving a preset
To save the current camera setup, follow this procedure:
1. In the Active measurements section, click Save preset.
10.4.17.2 Loading a preset
To load a saved preset file, follow this procedure:
1. In the Active measurements section, click Load preset. The standard Windows Open
dialog box appears.
2. Browse to the Downloads folder (or to the folder where you have stored the preset
files).
3. Select the file, and then click Open. This loads and applies the presets.

10.5 Administration tab

Note The Administration tab is only available for the admin role.
Under the Administration tab you can for example, manage firewall and network settings
and see system and firmware details.

10.5.1 Firewall

Use the settings on the Firewall page to configure how the functions and services of the
camera are allowed to be accessed.
Note The services also need to be enabled which is done on the Services page.

10.5.2 SSL certificates

A network client program that is setup to communicate with or control the camera re-
motely must be approved first, which is done on the SSL certificates page. The client up-
loads a certificate which is then shown in the Certificates list, and then the camera
administrator can approve the client. Approved clients can be revoked later on.
Temporarily enable the Auto approve functionality while setting up the network clients.
However, it is recommended to disable Auto approve when all setup is completed.

10.5.3 Services

Use the Services page to enable and disable the services of the camera.
Available services:
• Ethernet/IP
Enable this service when the camera is to communicate using industrial protocols
such as Modbus TCP and Ethernet/IP. The camera can be used as either a Modbus
client or a Modbus server. The settings for the Modbus client are located under the
Settings tab. If the camera should be used as a Modbus server, the registers can be
downloaded from the FLIR Customer support site.
• Pantilt server
Enable this service when the camera is connected to a Pan & Tilt unit. If the camera is
connected to the unit using an RS-232/485 interface, it can control the unit from the
Camera tab or by using ONVIF.
• httpResource
The httpResource service is an old way of controlling the camera. It should only be
enabled if legacy FLIR software is used.
• ONVIF
Enable this service when the camera is to communicate with Video Management Sys-
tems (VMS) over ONVIF. If the service is disabled, the camera will not be discovered
by third-party VMS. Note that the Advanced configuration is required on the camera
for ONVIF to work.
#T810579; r. AB/78918/78918; en-US
30