A.O. Smith CEWHR 35 User Manual page 17

Clock Set
The clock is Real Time Clock. Press "Clock
Set" button for 3 seconds, the hour time
(first two digits) starts blinking. Adjust the
hour time by pressing
press "Clock Set" button to set the hour time
and press "Clock Set" button again, the
minutes time (last two digits) starts blinking.
Adjust the minute time by pressing
button and press "Clock Set" button to set
the minute time. Now the clock time is set as
shown in (Fig. 23).
Figure 23
You can know the time by pressing the "Clock Set" button in power on mode. The time will
display for ten seconds, then return to temperature display mode as shown in (Fig. 22).
The clock time to be set before setting the Timing mode.
Default set temperature (factory setting) is 70°C.
or button and
or
3 sec
or
or
Temperature Setting
Press the
temperature is displayed on the LED
display. Wait for few seconds without
pressing any buttons, the value flashing in
the LED display will be changed as set
temperature and stored in memory. It will
return to its normal mode and the heating
of the water is based on the new set
temperature. While setting, the LED display
glows as shown in (Fig. 24).
Figure 24
NOTICE
NOTICE
14
or button until the required
or
or