A.O. Smith CEWHR 35 User Manual page 14

Installation of wired Remote control
For convenience of operation, please install the wired Remote control bracket on the wall near
the water heater. The length of the wire for the wired remote control is approximately 8 feet.
1. Mark the holes on the wall. The 2 holes should be aligned vertically. The vertical
distance between the 2 holes should be 24mm (Fig. 17).
2. Drill 2 holes of 30mm depth on the wall by using an electric Impact Drill tool (Fig. 8)
of diameter 6mm bit.
3. Fix the bracket on the wall by Expansion anchor and screw as shown in (Fig. 16).
Installation of Bracket for wired Remote
control
Figure 16
Wall
Bracket.
Bracket
Screw
Expansion anchor
Bracket for wired Remote control
Figure 17
WARNING
11
24mm