Speaker; Power Connector Cable - HP ProBook 445 G9 Maintenance And Service Manual

Speaker

To remove the speaker, use this procedure and illustration.
Table 6-9 Speaker description and part number
Description
Speaker
Before removing the speaker, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the system board (see
NOTE:
Remove the speaker:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the speaker to the computer.
2. Lift the speaker up and out of the computer (2). When installing the speaker, be sure that the rubber cap
in installed on the right end of the speaker (3) .
Reverse this procedure to install the speaker.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
58 Chapter 6 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
Battery on page
System board on page
Be sure that the RTC battery remains connected to the system board.
Preparation for disassembly on page
38).
48).
55).
Spare part number
M21400-001
38).