Handle & Dump Lever - Grizzly H5697 Instruction Manual

Handle & Dump
Lever
Components and Hardware Needed
Handle................................................................1
Handle Brace ....................................................1
Dump Lever........................................................1
Stop Plate ..........................................................1
Lever Safety Guard............................................1
Hex Bolts M8-1.25 x 25 ....................................4
Exterior Tooth Washers 8mm ............................4
Hex Nuts M8-1.25 ..............................................4
Hex Bolts M10-1.5 x 30 ....................................2
Exterior Tooth Washers 10mm ..........................4
Hex Nuts M10-1.5 ..............................................4
Hex Bolts M10-1.5 x 70 ....................................2
Tools Needed:
Wrench/Socket 13mm ......................................2
Wrench/Socket 16mm ......................................2
To install the handle and dump lever:
Attach the handle brace and handle to the
1.
front of the stand assembly with (4) M8-1.25
x 25 hex bolts, (4) 8mm exterior tooth wash-
ers, and (4) M8-1.25 hex nuts (Figure 22).
Figure 22. Handle and handle brace installed on
front of stand assembly.
H5697 Cement Mixer
Install the stop plate on the dump lever so
2.
the curved side is facing down, using (2)
M10-1.5 x 30 hex bolts, (2) 10mm exterior
tooth washers, and (2) M10-1.5 hex nuts.
3. Place the lever safety guard over the two
holes at the end of the dump lever and
Qty
secure the lever to the yoke with (2) M10-1.5
x 70 hex bolts, (2) 10mm exterior tooth wash-
ers, and (2) M10-1.5 hex nuts. Your final
assembly of the dump lever should look like
Figure 23.
Lever Safety Guard
Figure 23. Dump lever, stop plate, and lever
safety guard properly installed.
Stop Plate
-15-