Wheels - Grizzly H5697 Instruction Manual

Wheels

Components and Hardware Needed
Axle ....................................................................1
Axle Braces ........................................................2
Wheels ..............................................................2
Hex Bolts M8-1.25 x 25 ....................................4
Exterior Tooth Washers 8mm ............................6
Hex Nuts M8-1.25 ..............................................4
Set Screws M8-1.25 x 16 ..................................2
Hex Bolts M8-1.25 x 20 ....................................2
Flat Washers 8mm ............................................2
Tools Needed:
Wrenches/Sockets 13mm ................................2
Allen Wrench 4mm ............................................1
To install the wheels onto the stand assem-
bly:
1. Attach the axle braces to the rear of the
stand assembly with (4) M8-1.25 x 25 hex
bolts, (4) 8mm exterior tooth washers, and
(4) M8-1.25 hex nuts (Figure 19). Note—DO
NOT fully tighten these bolts at this time.
Figure 19. Axle brace mounted to rear of stand
assembly.
-14-
Slide the axle through both axle braces, so
2.
that it is evenly centered with the stand.
3. Use one set screw on each axle brace to
secure the axle in position, as shown in
Qty
Figure 20.
Figure 20. Securing axle to axle brace by
4. Tighten the axle brace mounting bolts.
5. Slide each wheel over each end of the axle.
Use (2) M8-1.25 x 20 hex bolts, (2) 8mm
6.
exterior tooth washers, and (2) 8mm flat
washers on the ends of the axles to secure
the wheels in place (Figure 21).
Figure 21. Wheel installed on axle.
tightening setscrew.
H5697 Cement Mixer