Drive System - Grizzly H5697 Instruction Manual

Figure 8. Yoke support connecting left and right
side stand assemblies.
6. Insert the front end of the yoke into the yoke
support and rest the rear end of the yoke on
top of the stand legs. Note—The front end of
the yoke is the end WITHOUT the groove.
7. Fit the inside cover over the rear end of the
yoke and slide the driving end plate into the
groove in the rear end of the yoke. Hold or
have your assistant hold the driving end plate
in position, and secure the driving end plate
and inside cover to the stand with (4) M10-
1.5 x 25 hex bolts, (4) 10mm ext tooth wash-
ers, and (4) M10-1.5 hex nuts (Figure 9).
Driving end plate and inside cover
Figure 9.
installed and supporting rear end of yoke .
Tighten all of the stand bolts that you left
8.
loose during assembly.
H5697 Cement Mixer
Yoke
Support
Inside
Pulley
Cover
Yoke
Driving
End Plate

Drive System

Components and Hardware Needed
Splash Guard ....................................................1
Motor Mount ......................................................1
Motor Pulley ......................................................1
Motor ..................................................................1
Upper Pulley Shaft w/Bushing ..........................1
Upper Pulley ......................................................1
V-Belts................................................................2
Outside Pulley Cover ........................................1
Pinion Gear ........................................................1
Flat Head Screws M5-.8 x 16 ............................6
Hex Bolts M8-1.25 x 20 ....................................4
Exterior Tooth Washers 8mm ............................4
Hex Nuts M8-1.25 ..............................................4
Hex Bolts M6-1 x 20 ..........................................4
Flat Washers 6mm ............................................4
Set Screw M8-1.25 x 8 ......................................1
Phillips Head Screws M6-1 x 20 ........................4
Phillips Head Screws M5-.8 x 10 ......................4
Set Screws M8-1.25 x 8 ....................................2
Tools Needed:
Phillips Screwdriver............................................1
Wrenches/Sockets 13mm ................................2
Wrench/Socket 10mm ......................................1
Allen Wrench 4mm ............................................1
To assemble the drive system:
Attach the splash guard to the motor mount
1.
with the (6) M8-1.25 x 20 flat head screws
(Figure 10).
Splash Guard
Motor Mount
Figure 10. Splash guard attached to motor
mount.
Qty
-11-