Dynacord L Series Installation Manual page 6

6 en | Safety
5.
6.
7.
8.
9.
10. Ensure that it is not possible to stand on the mains cable. Take precautions to ensure the
11. Only use accessories/extensions for the device that have been approved by the
12. Unplug the device if there is risk of lightning strike or in the event of long periods of
13. Have all service work and repairs performed by a trained customer service technician
14. Please ensure that no dripping water or spray can penetrate the inside of the device. Do
15. To ensure the device is completely free of voltage, unplug the device from the power
16. When installing the device, ensure that the plug is freely accessible.
17. Do not place any sources of open flame, such as lit candles, on top of the device.
18. This PROTECTION CLASS I device must be connected to a MAINS socket with a safety
Caution!
Use only manufacturer-approved carts, stands, brackets, or tables that you acquired together
with the device. When using carts to move the device, make sure the transported equipment
and the cart itself cannot tip over or cause injury or material damage.
IMPORTANT SERVICE INFORMATION
Caution!
This service information is for use by qualified service personnel only. To avoid the risk of
!
electric shock, do not perform any maintenance work that is not described in the operating
instructions unless you are qualified to do so. Have all service work and repairs performed by
a trained customer service technician.
1.
2.
2017.05 | 01 | F.01U.327.801
Do not operate the device in close proximity to water.
Use only a dry cloth to clean the unit.
Do not cover any ventilation slots. Always refer to the manufacturer's instructions when
installing the device.
Do not install the device close to heaters, ovens, or other heat sources.
Note: The device must only be operated via the mains power supply with a safety ground
connector. Do not disable the safety ground connection function of the supplied power
cable. If the plug of the supplied cable does not fit your mains socket, please contact
your electrician.
mains cable cannot become crushed, particularly near the device connector and mains
plug.
manufacturer.
inactivity. However, this does not apply if the device is to be used as part of an
evacuation system!
only. Service work must be carried out immediately following any damage such as
damage to the mains cable or plug, if fluid or any object enters the device, if the device
has been used in rain or become wet, or if the device has been dropped or no longer
works correctly.
not place any objects filled with fluids, such as vases or drinking vessels, on top of the
device.
supply.
ground connection.
Repair work on the device must comply with the safety standards specified in EN 60065
(VDE 0860).
A mains isolating transformer must be used during any work for which the opened device
is connected to and operated with mains voltage.
Installation manual
L Series and C Series FIR-Drive Power
Amplifiers
Bosch Sicherheitssysteme GmbH