Table of Contents
Advertisement
Solving Problems
The print settings and the paper size loaded in the printer are different.
Solutions
Change the print settings according to the paper size loaded in the paper cassette. Load paper in the
paper cassette that matches the print settings.
Multiple sheets of paper are fed into the printer at the same time.
Solutions
See the following to prevent multiple sheets of paper being fed into the printer at the same time.
"Several Sheets of Paper are Fed at a Time" on page 200
&
Paper Is Smeared or Scuffed
The following causes can be considered.
Paper is loaded incorrectly.
Solutions
When horizontal banding (perpendicular to the printing direction) appears, or the top or bottom of the
paper is smeared, load paper in the correct direction and slide the edge guides to the edges of the paper.
"Loading Paper" on page 37
&
The paper path is smeared.
Solutions
When vertical banding (horizontal to the printing direction) appears, or the paper is smeared, clean the
paper path.
"Cleaning the Paper Path for Ink Smears" on page 170
&
The paper is curled.
Solutions
Place the paper on a flat surface to check if it is curled. If it is, flatten it.
The printhead is rubbing the surface of the paper.
Solutions
When copying on thick paper, the print head is close to the printing surface and the paper may be
scuffed. In this case, enable the reduce scuff setting.
Select Settings > General Settings > Printer Settings, and then enable Thick Paper on the control panel.
If you enable this setting, copy quality may decline or may slow down.
>
Printing, Copying, Scanning, and Faxing Quality is Poor
>
276
Copy Quality is Poor
Advertisement
Table of Contents
