Table of Contents
Advertisement
Operating the appliance
en
Adding/removing laundry
After starting the programme (only for
washing), you can add or remove
laundry if necessary.
Touch the I Start/Reload button. The
appliance checks whether reloading is
possible.
If the following appears on the display
panel:
The symbol Õ disappears,
■
reloading is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch the
I Start/Reload button. The
programme continues automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the I Start/Reload button.
1.
Select another programme.
2.
And touch the I Start/Reload
3.
button again. The new programme
starts from the beginning.
If drying is activated, after
Note:
touching the I Start/Reload button,
when the Hot is displayed, waiting for
the appliance running to cool down the
laundry till the Hot disappears, then
select another programme.
38
Cancel the programme
For programmes washing at high
temperatures:
Touch the I Start/Reload button.
1.
To cool down laundry: Select Rinse
2.
¬.
Touch the I Start/Reload button.
3.
For programmes washing at low
temperatures:
Touch the I Start/Reload button.
1.
Select Spin 0 .
2.
Touch the I Start/Reload button.
3.
For programmes in drying process:
Touch the I Start/Reload button.
1.
If the Hot on the display panel,
2.
waiting for the appliance running to
cool down the laundry till the Hot
disappears.
Programme end
End lights up on the display and À and
Õ displays are off.
If you have selected 2, the water is only
drained after rinse process, no spin
cycle.
Notes
If Hot flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
If you do not take laundry out within
■
15 mins after drying process
finished, wrinkle guard process will
start to prevent laundry getting
wrinkled. The process lasts about 30
minutes. 0:00, £'˜, £© and "Ÿš will
be displayed alternately on the
display and Ó symbol will be
displayed as the status symbol. You
can touch any button to terminate
this process, then the door will be
released and laundry can be taken
out.
Advertisement
Table of Contents
