Adding/Removing Laundry; Changing The Programme; Cancel The Programme; Programme End - Siemens WN44A1L9DN User Manual And Installation Instructions

Adding/removing laundry

After starting the programme (only for
washing), you can add or remove
laundry if necessary.
Touch the I (Start/Reload) button.
The appliance checks whether
reloading is possible.
If the following appears on the display
panel:
The symbol Õ disappears,
■
reloading is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch the
I (Start/Reload) button. The
programme continues automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the I (Start/Reload)
1.
button.
Select another programme.
2.
And touch the I (Start/Reload)
3.
button again. The new programme
starts from the beginning.
If drying is activated, after
Note:
touching the I (Start/Reload) button,
when the •©£ is displayed, waiting for
the appliance running to cool down the
laundry till the •©£ disappears, then
select another programme.
Operating the appliance

Cancel the programme

For programmes washing at high
temperatures:
Touch the I (Start/Reload)
1.
button.
To cool down laundry: Select Rinse.
2.
Touch the I (Start/Reload)
3.
button.
For programmes washing at low
temperatures:
Touch the I (Start/Reload)
1.
button.
Select Spin/Drain.
2.
Touch the I (Start/Reload)
3.
button.
For programmes in drying process:
Touch the I (Start/Reload)
1.
button.
If the •©£ on the display panel,
2.
waiting for the appliance running to
cool down the laundry till the •©£
disappears.

Programme end

"Ÿš lights up on the display and À and
Õ displays are off.
If you have selected 2, the water is only
drained after rinse process, no spin
cycle.
Notes
If •©£ flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
en
39