Snmp Traps; Configuring Snmp - ZyXEL Communications NWA1123ACPRO-EU0101F User Manual

administrators collect statistical data and monitor status and performance. You can download the
NWA/WAC's MIBs from www.zyxel.com.

13.8.2 SNMP Traps

The NWA/WAC will send traps to the SNMP manager when any one of the following events occurs.
Table 71 SNMP Traps
OBJECT LABEL
linkDown
linkUp
authenticationFailure

13.8.3 Configuring SNMP

To change your NWA/WAC's SNMP settings, click Configuration > System > SNMP tab. The screen
appears as shown. Use this screen to configure your SNMP settings. You can also configure user profiles
that define allowed SNMPv3 access.
Figure 101 Configuration > System > SNMP
The following table describes the labels in this screen.
Table 72 Configuration > System > SNMP
LABEL
Enable
Server Port
Chapter 13 System
OBJECT ID
1.3.6.1.6.3.1.1.5.3
1.3.6.1.6.3.1.1.5.4
1.3.6.1.6.3.1.1.5.5
DESCRIPTION
Select the check box to allow or disallow users to access the NWA/WAC using SNMP.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
NWA / WAC Series User's Guide
160
DESCRIPTION
This trap is sent when the Ethernet link is down.
This trap is sent when the Ethernet link is up.
This trap is sent when an SNMP request comes from non-
authenticated hosts.