Table of Contents
Advertisement
Using the headphones
Pairing the headphones with a Bluetooth
device
1. Switch the headphones on
tooth device (max. 20 cm).
2. Press and hold the multi-function button for 5 seconds until you
hear the voice prompt "Pairing".
The LED flashes blue and red. The headphones are in pairing
mode.
3. Activate Bluetooth on your Bluetooth device.
4. Via the menu of your Bluetooth device, start the search for new Blue-
tooth devices.
All active Bluetooth devices in the proximity of your Bluetooth
device are displayed.
5. From the list of found Bluetooth devices, select "CX 150BT". If neces-
sary, enter the default pin code "0000".
If pairing was successful, you hear the voice prompts "Pairing
successful" and "Device (1) connected". The LED flashes blue
3 times.
1
ON
Hold
3s
3
4
Menu
Menu
Bluetooth on
Add Device
Bluetooth off
If no connection is established within 5 minutes, pairing mode
is terminated and the headphones switch to idle mode. If nec-
essary, repeat the steps described above.
Disconnecting the headphones from a
Bluetooth device
▷
Via the menu of your Bluetooth device, disconnect the connection
to the headphones.
The headphones are disconnected from the Bluetooth device.
You hear the voice prompt "Lost connection". The headphones
then search for other paired devices. If no device is found within
5 minutes, the headphones switch to idle mode.
(>
13) and place them close to the Blue-
2
Hold
5s
ON
< 20 cm
5
CX 150BT
"Pairing"
"Pairing
successful"
3x
"Device (1)
connected"
3x
CX 150BT | 11
Advertisement
Table of Contents
